Husqvarna R419TsX AWD Workshop Manual page 43

3. Fully press and release the parking brake 10 times.
4. Make sure that the servicing indicator symbol on the
display is not shown.
9.3.5 To remove and install the Operator presence
control (OPC)
1. Tilt the seat forward.
2. Disconnect the cable connections from the OPC.
3. Press and turn the OPC to remove it.
4. Install in opposite sequence.
9.3.6 To adjust the microswitch for the parking
brake pedal
1. Remove the transmission cover. Refer to
the covers on page 24 .
2. Do a check of the adjustment of the hydrostatic
transmission cable. Refer to
hydrostatic transmission cable on page 57 .
3. Remove the frame tunnel cover. Refer to
the covers on page 24 .
914 - 003 - 28.03.2019
To remove
To adjust the
To remove
4. Adjust the microswitch until it clicks when the
parking brake is pushed approximatley 40 mm / 1.5
in.
Note: Remove the spring for the parking brake cable
to make it easier to get access to the microswitch.
5. Attach the transmission cover and the frame tunnel
cover.
9.3.7 To disassemble and assemble the ignition
switch
1. Remove the outer right side cover. Refer to
remove and install the outer right side cover on page
26 .
2. Remove the ignition key (A).
3. Remove the plastic nut (B) and pull down the ignition
switch.
4. Pull the connector to disconnect it from the ignition
switch.
5. Assemble in opposite sequence. Make sure the
connector goes into the correct position.
To
A
B
Repair instructions - 43