Husqvarna R419TsX AWD Workshop Manual page 26

9.1.1.9 To remove and install the left footrest plate
1. Remove the frame tunnel cover. Refer to
and install the frame tunnel cover on page 25 .
2. Remove the 3 screws and remove the footrest plate.
3. Install in opposite sequence.
9.1.1.10 To remove and install the outer right side cover
1. Open the engine cover. Refer to
cover on page 24 .
2. Remove the 6 screws and remove the right side
cover.
3. Install in opposite sequence.
9.1.1.11 To remove and install the top right side cover
1. Remove the outer right side cover. Refer to
remove and install the outer right side cover on page
26 .
2. Disconnect the buttons attached to the top of the
right side cover.
3. Remove the knobs of the throttle lever and the
choke lever, if the product have a choke.
4. Remove the 4 screws and remove the top right side
cover.
5. Install in opposite sequence.
26 - Repair instructions
To remove
To open the engine
To
9.1.1.12 To remove and install the inner right side cover
1. Remove the top right side cover. Refer to
and install the top right side cover on page 26 .
2. Disconnect the power outlet connections (A).
B
3. Remove the nut (B) and push the power outlet
through the inner right side cover.
4. Loosen the screw (A) on the lift lever for the cutting
deck.
B
A
5. Remove the lift lever (B) for the cutting deck.
6. Remove the 3 screws and remove the right side
cover.
7. Install in opposite sequence.
To remove
A
914 - 003 - 28.03.2019