Fence; Tilt Knob And Fence Lock Handle; Cutter-Head Guard - Craftex CT201 Owner's Manual

Installing Tilt Knob and Fence
Lock Handle
The tilt lever is used to tilt the fence up
and down to your desired angle.
The fence lock handle a
the fence in that angle so that the fence
does not move while cutting operation.
Once you have installed the fence to the
carriage, take the fence lock handle and
install it to the fence carriage and attach
the tilt lever to the threaded hole on the
fence. (See figure 7)
Figure 7: Installing fence lock handle and
tilt knob
The cutter-head guard is a very
important safety
machine and must be installed properly
to avoid possible injuries.
ASSEMBLY
llows you to lock
feature of this
In stalling the Cutter-Head Guard
To install the cutter-head guard move the
fence backward so that you ha
s pace. Now insert the cutter-head guard
s haft and use the set screws to tight it.
(See Figure 8)
Figure 8: Installing cutter-head guard
The guard is provided with spring so that
when it gets pulled backward, it spring
back forwa rd over the cutter-head.
After you are done installing the guard,
test the guard by pulling it backward. If
the guard does not spring back over the
cutter-head, it means that the guard is
not installed properly.
following the directions above.
ve enough
Re-install it
12