Assembling The Fence - Craftex CX Series User Manual

2. Tighten the carriage mounting
bracket to the jointer table with the
cap screws, lock washers & flat
washers supplied. (Fig. K)
Figure K
Assembling the Fence Carriage
Components & Hardware Required:
Fence Carriage Assembly
Cap Screws M8-1.25 x 20
Lock Washers 8mm
Flat Washers
Tools required:
6mm Hex Key
1. With the fasteners listed above,
secure the fence carriage to the
carriage mounting bracket as in (Fig.
L)
Figure L

Assembling the Fence

Components & Hardware Required:
Fence Assembly
Cap Screws M8-1.25 x 25
Lock Washers 8mm
Flat Washers
Qty
Fence Tilting Handles
1
2
I.
2
2
Qty
1
Figure M
II.
13
Fasten the fence assembly to the
fence carriage using the M8-1.25 x
25 cap screws and washers supplied
as in (Fig. M)
Thread the fence tilting handle into
the fence assembly as in (Fig. N)
Qty
1
2
2
2
2