Example Of Saving And Recalling An Instrument Setup; To Remove (Clear) An Individual Save Register - HP 8920A User Manual

Example of Saving and Recalling an Instrument Setup

To Remove (Clear) an Individual Save Register

This example SAVES changes made to the RX TEST screen, and then RECALLS
them. The register is saved to wherever the
memory - unless you have changed it).
1. Access the RX TEST screen and set the RF Gen Freq to 500 MHz.
2. Set Amplitude to -35 dBm.
3. Press and release the SHIFT key then the RECALL key to access the SAVE function.
A prompt appears at the top of the screen asking you to enter a name.
4. Using the DATA keys, press 1 2 3 ENTER to assign a name to these changes.
5. Press PRESET and wait for the instrument to return to normal operation.
6. If not already displayed, access the RX TEST screen. Notice that the RF Gen Freq
and Amplitude settings are reset to their preset values.
7. Press RECALL 1 2 3 ENTER. The RF Gen Freq and Amplitude are changed to
the settings you saved in register 123 (500 MHz and -35 dBm).
Specify where the register is stored using the Save/Recall field on the I/O CONFIG-
URE screen.
1. Press RECALL.
2. Use the knob to position the cursor in front of the register to be removed from the Re-
call menu at the bottom-right of the screen. The register name and percentage of
memory occupied by that register are indicated at the top of the screen.
3. Press ON/OFF. A prompt appears, asking if you want to delete the save register.
4. Press YES.
Chapter 3, Operating Overview
Saving and Recalling Instrument Setups
field is set (
Save/Recall internal
77