To Reset The Instrument Setup - HP 54600B User, Installation And Service Manual

To reset the instrument setup

To reset the instrument to the default factory-preset configuration,
1
press
Press the
2
To reset the instrument to the configuration that was present before
3
pressing
Table 2-1
Default Setup configuration settings
Configuration Item
Cursors
Trace memories
Setup memories
Graticule
Autostore
Time base
Display
Channels
Trigger Mode
Trigger Condition
.
Setup
Default Setup softkey.
Autoscale, press the Undo Autoscale softkey.
Setting
Cursors off; time readout is selected; all cursors are set to time/voltage zero.
Both trace memory 1 and 2 are off; trace 1 memory is selected.
Setup memories are off; setup memory 1 is selected.
Grid set to Full
Off
Time reference center; main, not delayed sweep; main and delay value 0; 100 µs/div
main time base.
Vectors On, Display Mode Normal.
Channel 1 on, Position 0 V, Volts/Div 100 mV.
Auto Level, Coupling DC, Reject Off, Noise Reject Off.
Rising edge of channel 1
Operating Your Oscilloscope
To reset the instrument setup
2–33