Order; Pwr Lvl - HP 8920A User Manual

Chapter 6, Call Processing Subsystem
The CALL CONTROL Screen

Order

Pwr Lvl:

Page
134
S:\HP892XX\USRGUIDE\manual\callscrn.fb
This field is used to send an order on the forward voice channel to the Mobile
Station. A mobile station must be actively connected on a voice channel to the
Test Set (that is, the
Connect
order to a mobile station.
The field is a one-of-many selection field. To send an order to the mobile
Order
station, select the
Order
order from the
Choices:
Change Power to Power Level 0 - 7
• Maintenance (put the mobile station in maintenance mode)
Alert (alert the mobile station)
MRI (mobile reported interference) request (NAMPS system type only)
Once the selection is made a mobile station control message is sent to the mobile
station. The annunciator will light momentarily while the Test Set is
Access
sending the mobile station control message.
is divided into two fields:
Pwr Lvl:
• The left-hand field displays the mobile station's output power level assigned to the
voice channel being used by the Test Set and the mobile station. A numeric value is
displayed only when a mobile station is actively connected on a voice channel (that is,
the Connect annunciator must be lit). A "-" is displayed if a mobile station is not
actively connected on a voice channel.
• The right-hand field (highlighted field) is used to enter the Voice Mobile Attenuation
Code (VMAC). The VMAC determines the mobile station's power level to be used on
the voice channel (See
about the voice channel).
This field is used to initiate a page to the mobile station that is connected to the
Test Set. The Test Set must be in the active state (that is,
must be lit) and the
MS Id
page the mobile station.
annunciator must be lit) before you can send an
field. A list of choices is displayed. Select the desired
menu. The following orders are available:
Chan: field description, on page 125
information must be entered before you can attempt to
for more information
annunciator
Active