To Reset The Instrument Setup - HP 54616B User And Service Manual

To reset the instrument setup

To reset the instrument to the default factory-preset configuration,
1
press
Press the
2
To reset the instrument to the configuration that was present before
3
pressing
Table 2-1
Default Setup configuration settings
Configuration Item
Cursors
Trace memories
Setup memories
Graticule
Autostore
Time base
Display
Channels
Trigger Mode
Trigger Condition
See Also
"To Clear Error Messages" in the troubleshooting section of Service
chapter 4.
.
Setup
Default Setup softkey.
Autoscale, press the Undo Autoscale softkey.
Setting
Cursors off; time readout is selected; all cursors are set to time/voltage zero.
Both trace memory 1 and 2 are off; trace 1 memory is selected.
Setup memories are off; setup memory 1 is selected.
Grid set to Full
Off
Time reference center; main, not delayed sweep; main and delay value 0; 100 µs/div
main time base; sample rate is 5 MSa/s.
Vectors On, Display Mode Normal.
Channel 1 on, Position 0 V, Volts/Div 100 mV.
Auto Level, Coupling DC, Reject Off, Noise Reject Off.
Rising edge of channel 1
Operating Your Oscilloscope
To reset the instrument setup
2–35