Sat Freq (Fvc); Sat Level (Fvc: Amps-Tacs); Send Filler (Focc); Send Dsat (Fvc) - HP 8920A User Manual

Rf communications test set

Hide thumbs Also See for 8920A:

Table of Contents

SAT Freq (FVC)

This field is available only in AMPS-TACS mode.

This field sets the supervisory audio tone's frequency. This signal is sent

continuously whenever the FVC is selected, except while the Message is being

This field sets the supervisory audio tone's level. The unit-of-measure depends on

Operating Considerations

SAT is turned off while the FVC message stream is being sent.

Selecting this field causes the FVC or FOCC message to be output.

Operating Considerations

When sending an FOCC message stream, the contents of the

continuously output after the message data has been sent.

to stop the output.

Selecting this field causes the contents of the

Stream B to be output. The fillers continue to be output until

This field is available only in NAMP-NTAC mode.

Selecting this field causes the contents (24 bits) of the

continuously output until

, the DSAT data is output continuously after the message is output.

Chapter 10, Signaling Encoder (AF Generator 2)

is selected. If a message or DST is sent by

AMPS-TACS NAMPS-NTACS Encoder

fields for Stream A and

Show Quick Links

Table of Contents