Originate A Call With Authentication - HP 8920A User Manual

Originate a Call with Authentication

1. Ensure that the Test Set is in the active state.
Channel" on page 143
2. Connect the mobile station to the Test Set as shown in
Mobile Station to the Test Set," on page
3. Turn on the mobile station.
4. If the CALL CONTROL screen is not displayed, select CALL CNTL under the To
Screen menu. The CALL CONTROL screen will be displayed.
5. Position the cursor on the Display field and select Data.
6. Ensure that the mobile station has registered with the Test Set.
Processing with Authentication" on page 154
mobile station.
7. Dial the desired phone number on the mobile station and press the SEND key on the
mobile station's handset. The mobile station signals the Test Set on the reverse control
channel with an origination message which includes the dialed phone number, the
mobile station's MIN number and the mobile station's ESN. If the mobile station
transmitted properly on the reverse control channel, the message RECC Return will
flash momentarily in the upper right-hand corner of the CALL CONTROL screen and
then the mobile station's phone number, ESN, decoded SCM, and called phone number
will be displayed. The Test Set will then reconfigure itself to the voice channel
assignments set up in the Voice Channel Assignment section of the CALL
CONTROL screen. The Access annunciator will then light while the Test Set signals
the mobile station on the assigned voice channel. The Connect annunciator will light
if the mobile station properly signals the Test Set on the reverse voice channel. The
mobile station is now connected to the Test Set on the assigned voice channel. The
Voice Channel Assignment fields will be replace with appropriate information.
If origination with authentication was successful, then "Origination w/Auth
successful" will be displayed in the upper right-hand portion of the CALL
CONTROL screen. If origination with authentication failed, then "Origination w/
Auth failed" will be displayed in the upper right-hand portion of the CAll
CONTROL Screen.
Using the CALL CONTROL Screen to test AMPS Authentication
See "Turn On The Test Set's Control
for information on how to activate the Test Set.
119.
for information on how to register the
Chapter 6, Call Processing Subsystem
Figure 17, "Connecting a
See "Initialize Call
157