Setting Up The Oscilloscope; Setting Up The Oscilloscope; To Inspect The Instrument; To Check Power Requirements - HP 54520 Series Service Manual

CAUTION
Setting Up the Oscilloscope
This section will help you get the instrument ready to use. Included here are
procedures for:
e Inspection
e Checking and setting power requirements
e Cleaning
To inspect the instrument
Inspect the shipping container for damage.
Keep a damaged shipping container or cushioning material until the contents of the shipment
have been checked for completeness and the instrument has been checked mechanically and
electrically.
Check the accessories.
Accessories supplied are listed in chapter 1 of this service guide.
® Ifthe contents are incomplete or damaged notify your HP sales office.
Inspect the instrument.
© If there is mechanical damage or defect, or if the instrument does not operate properly or
pass performance tests, notify your HP sales office.
If the shipping container is darnaged, or the cushioning materials show signs of stress,
notify the carrier as well as your HP sales office. Keep the shipping materials for the
carrier's inspection. The HP office will arrange for repair or replacement at
Hewlett-Packard's option without waiting for claim settlement.
To check power requirements
The instrument requires a power source of 115 Vac or 230 Vac, —-22% to +15%, 48 to 440 Hz,
350 VA maximum.
BEFORE CONNECTING POWER TO THIS INSTRUMENT, be sure the line voltage switch on
the rear panel of the instrument is set properly. Applying a voltage excessive to the setting
may open the protective fuse.
2-3