Rf Level Offset; Rf Offset - HP 8920A User Manual

RF Level Offset

RF Offset

This field enables/disables the RF level offsets entered in the
, and
Duplex Out Antenna In
• When set to On, the RF Generator's amplitude and RF Analyzer's power measurement
are offset by the values entered in these fields.
• When set to Off, the values in these fields are ignored.
See Also
Antenna In field description, on page 255
Duplex Out field description, on page 258
RF Chan Std field description, on page 262
This field is displayed when the RF Display field has Freq selected.
This field enables/disables the RF Generator
specified in the
(Gen)-(Anl)
Operating Considerations
When an RF offset is used, changing the RF Generator's frequency or RF
Analyzer's tune frequency automatically alters the other setting. On screens
where both fields are not shown (such as the RX TEST and TX TEST screens),
you will not see the corresponding field change.
See Also
"Setting an RF Generator/Analyzer Offset" on page 84
fields below it.
−
RF Analyzer frequency offset
field below it.
Chapter 7, Configure Screen
Field Descriptions
,
RF In/Out
265