Tractor Preparation; Vt Plus Preparation - Landoll VT PLUS 7430 Operator's Manual

4-1 TRACTOR PREPARATION

The Landoll 7430 VT Plus is designed to be
pulled by tractor equipped with a double lip or
clevis type hitch. If your tractor is not equipped as
such, you need to purchase the hitch from your lo-
cal tractor dealer. If your VT Plus is equipped with
the clevis option, this should be removed. The
clevis option is only for transport use.
Before attaching the VT Plus, prepare the trac-
tor as follows:

4-2 VT PLUS PREPARATION

7430 scraper adj
Figure 4-1 Disc Scraper Adjustment to Disc
4-2
1/8"
Blade
4-1.1 Inflate the rear tractor tires equally and
add ballast according to the tractor opera-
tor's manual.
4-1.2 Lock the tractor drawbar in the center
position.
4-2.1 Prior to operating the 7430 VT Plus, in-
spect it thoroughly for good operating condi-
tion.
4-2.2 Replace worn or missing parts.
4-2.3 When the machine is new, check the
bolt tightness after a few hours of operation.
Tighten any loose nuts or bolts. Check the lift
wheel lug bolts daily.
4-2.4 Check the lift wheel tire inflation. Inflate
all tires equally to avoid side draft. Follow the
tire manufacturer's recommended pressures
listed on the sidewall of the tires.
4-2.5 Check disc scrapers for proper adjust-
ment to the disc blade. (See Figure 4-1).
4-2.6
Lubricate the machine as shown in Sec-
tion 4-20 (See Figure 4-20).