Manual Leveler - Landoll VT PLUS 7430 Operator's Manual

3-3 MANUAL LEVELER

3-3.1 Using the manual leveler, screw the lev-
eler tube onto the leveler screw assembly
(See Figure 3-3). Initially leave approxi-
mately 3" of threads visible, further adjust-
ment may be required. Rotate the tube so
that the zerk hole in the threaded end is
pointing upward.
3-3.2 Install the manual leveler handle assem-
bly into the front end of the leveler tube and
fasten with two 5/8-11 x 3-1/2 hex head cap
screws and hex lock nuts. Insert a plastic
wear flange bearing into the flat side of each
leveler cross bracket. Slide the brackets over
each side of the manual leveler cross and
secure with washers and 5/16" x 2-1/2"
spring slotted pins.
3-3.3 Attach the leveler cross brackets to the
top of the leveler L link using 3/4-10 x 3-1/2
hex head cap screws and hex lock nuts.
3-3.4 Install a grease zerk in the threaded
end of the leveler tube.
3-7