Wing Frames - Landoll VT PLUS 7430 Operator's Manual

3-9 WING FRAMES

3-9.1 Place the wing frames on top of the
wing gang assemblies and attach using
3/4-10 x 2 hex head cap screws and hex
lock nuts (See Figure 3-10).
3-9.2 Assemble the tire and wheel assemblies
(p/n 142648) to the wing frames (See Fig-
ure 3-9)..
3-9.3 Attach the front gauge wheel assem-
blies to the wing frames using 1-8 x 6 hex
head cap screws, gauge wheel spacers, and
hex lock nuts. Securely tighten the mounting
screws to eliminate any slack and unneces-
sary wear.
3-9.4 Mount the wing stabilizer brackets to the
wing frames using u-bolts and hex lock nuts.
See Figures 2-3 - 2-8 for placement
dimensions.
Note: On 23', 26', and 29' models, the wing sta-
bilizers mount to the sides of the wing frame.
On 33' models, the wing stabilizers mount to
the tops of the wing frames.
3-9.5 Install a 1/4 x 3 roll pin in one end of
each wing lock pin. Insert the pin in the
round hole of the front wing stabilizers and
secure with a 3/16 hair pin.
3-17