Table of Contents
Advertisement
4-8.4
Leveling the VT Plus side-to-side in-
volves leveling the wing frame to the center
frame. The unit should be level side-to-side
when operating in the field.
4-8.5
To level the unit:
a. Verify that all tires are properly inflated, and
that the center radius rod adjustment has
been properly set.
b. With the implement unfolded, raise the unit
to fully extend the lift cylinders. Continue to
hold the tractor lever 30-60 seconds to insure
that the cylinders are fully extended and the
rephasing lift system has been purged of air.
c. Lower the unit until the disc blades are ap-
proximately 1" off the ground.
d. On the center frame, measure the distance
from the walking beam spindle to the top side
of the frame (See Figure 4-8)
e.
Measure the same distance on the wing
frame. The wing frames are generally set to
the same distance or slightly higher than the
center frame.
f. Adjusting the anchor at the base end of
each wing lift cylinder sets wing frame height
(See Figure 4-9).
4-8.6
An adjusting wrench is provided to
make this adjustment. It may be necessary
to lower the wing to the ground and relieve
weight on the cylinder anchor to make this
adjustment. If required, fully raise the imple-
ment, lower to just above the ground, and
re-verify measurements. Repeat as neces-
sary and securely tighten the cylinder anchor
when complete.
7430levelmeas
Figure 4-8 Leveling from Side to Side
BASE END
ADJUSTMENT
WING
FRAME
6230wingliftadj
Figure 4-9 Wing Lift Adjustment
MEASURE
3-3/4 x 10
HYDRAULIC
CYLINDER
WING LIFT
WHEEL
ASSEMBLY
4-9
Advertisement
Table of Contents
