Mdtp (Manual Date Time Programming) (Zmr100Xr Only); Manual Setting Of Date/Time/Id - Landis+Gyr E230 User Manual

60/84
Example billing readout
1.6.0(02.250*kW)(11-12-28 12:00)
1.6.0*21(02.160*kW) (11-11-28 12:00)
1.6.0*20(02.015*kW) (11-10-28 12:00)
1.6.0(02.250*kW)(11-12-28 12:00)
1.6.0*21(02.160) (11-11-28 12:00)
1.6.0*20(02.015) (11-10-28 12:00)
6.9

MDTP (Manual Date Time Programming) (ZMR100xR only)

6.9.1

Manual setting of date/time/ID

© Landis+Gyr
The Date, Time and IDs can be programmed using the meter's push
buttons. The meter must feature a Maximum Demand button to perform
this operation. Configuration is required to enable/disable this feature. A
log records the number of times the Date and/or Time is reprogrammed.
This is displayed with the first and second displays during MDTP. "rdt" is
the date when the last date or time parameter has been changed by
MDTP. "rct" is the count/number of changes made to date or time since
reset. The count goes up to 99 before rolling over to 00.
The procedure is as follows (assuming feature is enabled):
After one short press (< 3 seconds) of the Maximum Demand push
button, the meter enters a separate display cycle. The display list shows
all of the parameters that can be programmed through the MDTP mode.
Subsequent short presses (< 3 seconds) of the Maximum Demand push
button will advance the display to the next parameter. The parameter list
is sequenced as follows:

"rdt" - Reprogramming date: date of last programming (read only)

"rct" - Reprogramming counts: the number of times the Date or Time
has been programmed via the push button (read only)

Date* (0.9.2)

Time* (0.9.1)

ID1.1 (0.0.0)

ID1.2 (0.0.1)

ID1.3 (0.0.2)

ID1.4 (0.0.3)

ID2.1 (C.1.0)

ID2.2 (C.1.1)
* ZMR100xR only.
D000044352 en g – E230 Residential Electricity Meter – ZxR100xC/ZMR100xR – User Manual
Comments/remarks
Units of stored values included (Suppress Units In
Billing disabled).
Current value must always contain unit, e.g. kW.
Stored value with units.
Stored value with units.
Units of stored values not included (Suppress
Units In Billing enabled).
Current value must always contain unit, e.g. kW.
Stored value without units.
Stored value without units.
Operation