Energy Registers - Landis+Gyr E230 User Manual

Operation
6.2

Energy registers

D000044352 en g – E230 Residential Electricity Meter – ZxR100xC/ZMR100xR – User Manual
Total meter operating time
Example X (OBIS code C.8.0)
All segments on – test display
Example Y
The display of energy registers is configurable to show 5 or 6 whole
numbers and between 0 and 3 decimal places with a maximum of 8
digits. All energy registers are displayed with leading zeros and will roll
over from 999 999.99 to 000 000.00. These can be reconfigured by
using the formatted commands made available in .MAP110.
All energy registers are incremented for every 1 Wh, VArh or VAh of
energy consumed.
The meter has up to six (in E230 ZxR100xC) or eight (in E230
ZxR100xC) user-defined energy registers (or channels), each of which
can be configured to measure for example:
Energy Type
Direction
Source
Instantaneous
Values
The meter also has four externally switched Rate registers.
The following table shows the arrangement of the total and rate
registers. In all cases, only one rate register is active for each
measurement channel.
kWh, kVAr or kVAh
Forward, Reverse, +/-Reactive
Individual Phase, Summed, etc.
Voltage, Current, Frequency, Phase Angle, etc.
47/84
© Landis+Gyr