Landis+Gyr E230 User Manual page 50

50/84
Event Name
no.
8 Billing period
reset
9 Daylight
saving time
enabled or
disabled
10 Clock
adjusted (old
date/time)
11 Clock
adjusted
(new
date/time)
17, 18, Under-
19 voltage L1,
L2, L3
20, 21, Overvoltage
22 L1, L2, L3
23 Power down
24 Power up
25, 26, Overcurrent
27 L1, L2, L3
28, 29, Voltage
30 without
current L1,
L2, L3
31 Power factor
monitor 1
33, 34, Demand
35, 36 monitors 1, 2,
3 and 4
37, 38, Phase
39 reversal L1,
L2, L3
© Landis+Gyr
Description
Indicates that a billing period
reset has occurred.
Indicates a change from and to
daylight saving time. The time
stamp shows the time before
the change.
Indicates that the date/time
has been adjusted. The time
that is stored in the event log is
the old time before the
adjustment was made.
Indicates that the date/time
has been adjusted. The time
that is stored in the event log is
the new time after the
adjustment was made.
Indicates that an undervoltage
has occurred on the
corresponding phase.
Indicates that an overvoltage
has occurred on the
corresponding phase.
Indicates that a power failure
has occurred.
Indicates that a power up has
occurred.
Indicates that an overcurrent
has occurred on the
corresponding phase.
Indicates a possible shorting of
the current coil.
Indicates that the power factor
is below a set limit.
Indicates that the demand is
above a set limit.
Indicates a reversal of polarity
of the current coil.
D000044352 en g – E230 Residential Electricity Meter – ZxR100xC/ZMR100xR – User Manual
Trigger Event Anti-
fraud
X
X
X
X
X
X
X
X
X
X
X
Operation
Perma-
nent
trigger
(confi-
gurable)
X X
X X