Push Button Operation - Landis+Gyr E230 User Manual

48/84
Signal Input
Measurement Measurement
channel 1 channel 2
Rate register Rate register
1 1
Rate register Rate register
2 2
Rate register Rate register
3 3
Rate register Rate register
4 4
Total register Total register
6.3

Push button operation

© Landis+Gyr
Measurement
channel 3
Rate register
1
Rate register
2
Rate register
3
Rate register
4
Total register
The meter is fitted with up to two push buttons. The green Display button
(blue in pre-Release 2 meters) is used for stepping through the meter's
display cycle. Each press will advance the configured display sequence
by one display.
The standard display cycle is configurable with a maximum of 32
(ZxR100xC) or 64 (ZMR100xR) displays. There is an option to have an
extended display cycle. The extended cycle is a maximum 64
(ZxR100xC) or 128 (ZMR100xR) displays and is accessed by pushing
and holding down the Display button for ≥ 3 seconds.
If the display sequence has been partially cycled and the push button is
not pressed for a period of time, the display sequence will revert to the
default display.
The orange MD button (if fitted) can be used to perform MTDP (Manual
Time and Date Programming) (ZMR100xR only), accessing P3 security
level (ZMR100xR only) and resetting of Maximum Demand/Manual
Billing reset, see section 6.7.4. If parameterised, the MD button can be
used to reset alerts in the installation mode when "End" or "All
Segments" are displayed (ZMR100xR only). The MD button is an
optional feature and allows for fitment of a wire and ferule (or similar)
utility seal.
D000044352 en g – E230 Residential Electricity Meter – ZxR100xC/ZMR100xR – User Manual
Measurement Measurement
channel 4 channel 5
Rate register Rate register
1 1
Rate register Rate register
2 2
Rate register Rate register
3 3
Rate register Rate register
4 4
Total register Total register
Operation
Measurement
channel 6
Rate register
1
Rate register
2
Rate register
3
Rate register
4
Total register