Config Menus - AJA Ki Pro Ultra Installation And Operation Manual

19.4 Custom Take
This parameter defines a custom take. The custom take number is defined via the
front panel User Control Knob.
1 to 999
(default = 1)
22. 1 Gang Clip Name
This parameter is used when performing gang recording via multiple Ki Pros and/
or Ki Pro Ultras (refer to Controlling Multiple Ki Pros later in this manual). If the
desire is to have clips named the same across all Ki Pro ganged units' recordings,
then use the "Master Name" selection in this parameter. If the desire is to have
clips named independently on Ki Pro units, then "Subordinate Name" should be
selected. Selecting "Subordinate Name" means that the recording will take its
name from the individual Ki Pro's parameters and not accept the value pushed to
the Subordinate by the Master Ki Pro.
Master Name (default)
Subordinate Name
NOTE: Most gang controls are only available in the web user interface.
22.4 Captions
This parameter is used to capture of CEA-708 Closed Captioning data as
QuickTime movie tracks.
On recording, Ki Pro Ultra extracts CEA-708 (including 608 within 708) packets
contained in the vertical ANC data embedded in the SDI input (BNC or Fiber)
signal. The packets are processed and inserted into a QuickTime track (CLCP) as
part of the recorded QuickTime container.
Disabled (default)
Enabled
On playback, Ki Pro Ultra will process the QuickTime container file, process the
CLCP track if present and insert/embed closed captioning data on the main
SDI outputs (BNC or Fiber) VANC. No user configuration is required for caption
playback.
NOTE: Closed captioning is not supported on HDMI inputs/outputs or the SDI monitor

Config Menus

As in the Media menus already presented, pressing the User Control Knob and
scrolling changes the current Config parameter's value to a new one from the
Ki Pro Ultra's list of choices—repeating the list if you continue to scroll—or
adjusting a numerical value up or down.
The exact choices displayed will vary depending on the parameter. Most
adjustment choices made with the Control Knob take effect immediately and will
be subsequently stored into the Ki Pro Ultra's non-volatile memory if they remain
unchanged for 3 seconds.
Ki Pro Ultra File Based Recorder/Player v3.3r1
Press the Control Knob and scroll to change the Take value from 1
Enable clips to be named the same across all Ki Pro ganged units
Name clips independently on Ki Pro units
No caption track will be created nor will any arriving captions be
Writes any captioning data that arrives during the recording into
output.
to 999, if a value other than the automatically generated value
is desired.
written to the clip.
a QuickTime track (CLCP).
43 www.aja.com