AJA Ki Pro Ultra Installation And Operation Manual page 34

Figure 15. Warning Examples
Once there is a Ki Pro Ultra alarm active, the STATUS button light will blink for
as long as the alarm is present. This alerts you so you'll know the reasons for
the alarm condition are still active—you can then check the ALARMS display
by pressing the STATUS button and using the User Control Knob to scroll to the
ALARMS tab.
If you enter the Config or Media menus after an alarm notification, the alarm
display will go away. Pushing any button always returns Ki Pro Ultra to its pre-
alarm state—however, if you are unable to correct the alarm condition after
this initial button push, when you leave these menus, the alarm notification will
reappear on the display.
Ki Pro Ultra features a variety of alarms to help you diagnose the condition of the
unit, possible configuration issues, or possible signal issues.
Warning: Input Format Changed -
and the signal is lost or changed. If this occurs, Ki Pro Ultra stops the recording
that is in progress (unless the Loss of Video Config menu parameter is set to
continue recording.)
Warning: No Video Input -
No recording will be performed in this state.
Warning: Input Error -
is supplied to the Ki Pro Ultra or a link of a multi-link signal (dual link or quad
link) is missing; no recordings will be produced if this alarm appears.
Warning: Dropped Frames -
cannot keep up with the data rate required to make a recording or perform a
playback. If you see this prompt during recording, recordings will stop. If this
prompt appears, you might consider backing up your current recordings and
formatting the media. For playback, you might simply re-attempt playback.
Warning: Media Low -
remaining. Media must be switched out when it reaches 10% of capacity. With
10% of media remaining, the "Warning: Media Full" prompt will appear.
Warning: Media in Use -
operation is still taking place. Wait for the operation to finish and then try
again or press STOP.
Warning: Media Not Present -
and the user hits the slot button.
Ki Pro Ultra File Based Recorder/Player v3.3r1
This prompt appears if a recording is started
May appear if there is no video input to Ki Pro Ultra.
May appear if a format or frame rate that is not supported
May appear if media is under-performing and
Appears when the media only has 15% of capacity
May appear if you try to use media while another
May appear if media has been physically removed
34 www.aja.com