Custom Take; Gang Clip Name; Captions; Config Menus - AJA Ki Pro Ultra Installation & Operation Manual

19.4 CUSTOM TAKE

22.1 GANG CLIP NAME

22.4 CAPTIONS

CONFIG menus

Ki Pro Ultra v1.2r1
This parameter defines a custom take. The custom take number is defined via the front
panel User Control Knob. These are the options:
1 to 999
(default = 1)
This parameter is used when performing gang recording via multiple Ki Pros and/or Ki
Pro Ultras (refer to Controlling Multiple Ki Pros later in this manual). If the desire is to have
clips named the same across all Ki Pro ganged units' recordings, then use the "Master
Name" selection in this parameter. If the desire is to have clips named independently on
Ki Pro units, then "Subordinate Name" should be selected. Selecting "Subordinate Name"
means that the recording will take its name from the individual Ki Pro's parameters and
not accept the value pushed to the Subordinate by the Master Ki Pro. These are the
options:
Master Name (default)
Subordinate Name
NOTE: Most gang controls are only available in the web user interface.
This parameter is used to capture of CEA-708 Closed Captioning data as QuickTime
movie tracks.
On recording, KiPro Ultra extracts CEA-708 (including 608 within 708) packets contained
in the vertical ANC data embedded in the SDI input (BNC or Fiber) signal. The packets are
processed and inserted into a QuickTime track (CLCP) as part of the recorded QuickTime
container. These are the options:
Disabled (default)
Enabled
On playback, KiPro Ultra will process the QuickTime container file, process the CLCP track
if present and insert/embed closed captioning data on the main SDI outputs (BNC or
Fiber) VANC. No user configuration is required for caption playback.
NOTE: Closed captioning is not supported on HDMI inputs/outputs or the SDI monitor output.
As in the MEDIA menus already presented, pressing the User Control Knob and scrolling
changes the current CONFIG parameter's value to a new one from the Ki Pro Ultra's list of
choices—repeating the list if you continue to scroll—or adjusting a numerical value up
or down.
The exact choices displayed will vary depending on the parameter. Most adjustment
choices made with the Control Knob take effect immediately and will be subsequently
stored into the Ki Pro Ultra's non-volatile memory if they remain unchanged for 3
seconds.
Press the Control Knob and scroll to change the
TAKE value from 1 to 999, if a value other than the
automatically generated value is desired.
Enable clips to be named the same across all Ki Pro ganged
units
Name clips independently on Ki Pro units
No caption track will be created nor will any arriving captions
be written to the clip.
Writes any captioning data that arrives during the recording
into a QuickTime track (CLCP).
45
www.aja.com