AJA Ki Pro Ultra Installation And Operation Manual page 52

9.2 Interval Time
Determines the time period from which the interval frames are selected.
Second
Minute
Hour
32.0 Loss of Video
This parameter selects whether recording continues when valid video is not
present.
Stop Rec (default)
Cont Rec
NOTE: If CONT Rec is selected, and a loss of video is encountered, a graphic with the text
35.2 Remote Control
This parameter is for setup of remote RS-422 machine control.
Local Only (default)
RS-422 Only
Control from RS-422
To control the Ki Pro via the RS-422 port, this Configuration option must be set
to RS-422 Only. If this option is not set, the device will look to the controller as if
the tape is ejected. Once a clip is selected, frame accurate playback control of the
current clip is immediately possible. The timecode format delivered via RS-422
will be dependent upon the current clip. Note that the device will allow you to
shuttle to anywhere in the full 24-hour timecode, but the current clip will exist
at the clip's own timecode. Playlists are supported as long as the clips are of the
same format and frame rate.
Capture Control from RS-422
To perform an edit-to-tape function, the selected clip must be in the format,
rate, and timecode you want to capture. If you don't yet have a clip in your input
format, you can create one by manually capturing a short clip of the input you'll
be editing. Once this clip is selected, you can then shuttle to any point in the
24-hour timecode. Your edit can take place anywhere in the 24-hour timecode.
The device does not differentiate between insert or assemble, nor does it support
video, audio or timecode only edits. Each edit operation will produce a new clip
at the edit in point with a duration equal to the edit. The clip will contain all video
and audio fed to the device. You will not be able to insert into an existing clip. Be
aware that you should set your pre-roll to five (5) seconds or greater to allow the
device sufficient time to lock to the video input.
41. 1 Video SG Frmt
This parameter determines the video format output from Ki Pro Ultra's internal
test signal generator. This parameter is used with parameter 41.2 to determine
the type of video test signal output by Ki Pro Ultra.
NOTE: While the Ki Pro Ultra may be configured for a YCbCr or RGB signal generator, the
Ki Pro Ultra File Based Recorder/Player v3.3r1
"LOSS OF VIDEO" superimposed over color bars will appear. Be sure to check your
source and video connections if you are experiencing a loss of video.
output is ultimately determined by the selection made in the 1.6 SDI Out menu
parameter.
The second from which interval frames are selected.
The minute from which interval frames are selected.
The hour from which the interval frames are selected.
Recording stops when video is lost
Recording continues when video is lost
Enables local control only. RS-422 is disabled.
Enables RS-422 control
52 www.aja.com