AJA Ki Pro Ultra Installation And Operation Manual page 61

Ki Pro Ultra on your network). If Ki Pro Ultra is using DHCP (the default), the IP
address can be found by going to parameter 50.2 and reading it there. When
Ki Pro Ultra is shipped from the AJA factory, it defaults to DHCP operation. The
DHCP selection is most useful in studio settings where the camera or cameras
may be connected to an existing IT infrastructure.
If 50.1 is set to DHCP, and the DHCP server on the network fails to grant an IP
address, then Ki Pro Ultra's 50.2 DHCP Address menu parameter will display
0.0.0.0. No connection to the device can be made with this address. Check with
your network administrator if you experience issues connecting to the device
over a DHCP network.
If 50.1 is set to Default Addr, the factory default static IP address 10.65.74.65 is
used. So, if 50.1 is set to Default Addr, to see Ki Pro Ultra's web interface, you
would type the following in the web browser:
http://10.65.74.65
NOTE: Your computer or network must be configured to access this IP address. You may
Figure 18. Default IP Address Configuration
For direct connections between a computer and Ki Pro Ultra, you may elect to use
the Static Addr selection. This allows you to select an IP address for Ki Pro Ultra
and apply it. For example, you could enter 192.168.0.2 as an IP address. Then, to
see Ki Pro Ultra's web interface, you would type the following in the web browser:
http://192.168.0.2
NOTE: Your computer or network must be configured to access this IP address. You may
Ki Pro Ultra File Based Recorder/Player v3.3r1
need to make changes to your network settings on your host computer to access
this IP address.
need to make changes to your network settings on your host computer to access
this IP address.
61 www.aja.com