AJA Ki Pro Ultra Installation And Operation Manual page 12

NOTE: When power is first applied to Ki Pro Ultra, the unit powers up immediately
NOTE: Upon power up with both slots populated, Slot 1 is the initial storage system
In normal operation to turn power on, press the button once. It isn't necessary
to press hard—it's a "soft" button sensed by the processor inside. Pressing the
button will begin power-up and display start-up progress on the alphanumeric
display.
To power down, press and hold the power button down for 3 seconds while the
display counts down. This process prevents accidental power-off during normal
operation. You can abort the power-down process by simply removing your
finger from the power button before the 3 seconds have elapsed.
DISP Button
Use the display button to toggle video overlay display modes. Sequential presses
of the button step through these display modes:
1. No overlay – display is video monitor only
2. Top and bottom status overlay
3. Top and bottom status overlay plus VU meters
The display button can be used to hide the Config or Status overlay if it is active.
User Control Knob
The User Control Knob on the right side of the Ki Pro Ultra front panel is used to
scroll through and select menu items. After scrolling to, and high-lighting a menu
item of interest, push the knob to select. To pop out of a selected menu item, use
the rotator knob to highlight EXIT and push the knob to return to the top level.
When not in a configuration mode and media is mounted with clips available,
you can use the selection knob to scroll through the clips. Press the knob once to
enable JOG mode to step through the clip a frame at a time.
STATUS Button
When it is not highlighted, you can press the STATUS button to display the status
overlay. Status includes video input, format, record format, and audio setup
information. Once selected, the selector knob can be rotated to display either
the Status or ALARM tab. If any ALARMS or WARNINGS are active, they will be
displayed under the ALARMS tab.
When it is highlighted, pressing the STATUS button hides the Status overlay.
A blinking Status button indicates Alarms are present. Press the STATUS button to
immediately display the ALARM tab.
NOTE: When necessary, you can initiate a "safeboot" of the Ki Pro Ultra to factory presets
CONFIG Button
When it is not highlighted, you can press CONFIG to access the Ki Pro Ultra
configuration menu overlay. If the transport is active—video is playing or
being recorded—you will be prompted to stop the transport before entering
configuration mode. Use the User Control Knob to respond to system prompts
by rotating and pushing to select. Once in configuration mode the User Control
Knob can be rotated to scroll the menu system. Push the User Control Knob to
enter a selected menu, scroll through the selections, push to select a setting. To
leave a menu, scroll to Exit and press the knob.
MEDIA Button
When it is not highlighted, you can press the MEDIA button to enter the Media
menu. Pressing MEDIA when it is highlighted will turn Off the Media menu
(returning to the default Transport menu). The Media menu can only be entered
Ki Pro Ultra File Based Recorder/Player v3.3r1
(without pressing the button. This facilitates a quick return to operation if there is
a power interruption.
accessed by Ki Pro Ultra.
by holding in the STATUS button while powering up.
12 www.aja.com