AJA Ki Pro Ultra Installation And Operation Manual page 50

• Channels 9 & 10
• Channels 11 & 12
• Channels 13 & 14
• Channels 15 & 16
2.5 16 Ch - 8 Ch Audio Map
This parameter allows you to select the input channel mapping for 8 channel
Audio destinations (HDMI, AES, and Analog Audio). There are two options:
Lower (Chs 1-8) (default)
Upper (Chs 9-16)
For 8 Channel Audio Inputs (AES, Analog Audio and HDMI), the 8 channels are
always mapped to the lower 8 channels on SDI (BNC and Fiber) outputs. You
cannot map the 8 channels of input to the upper 8 channels (9-16) of your SDI
destination.
For Ki Pro Ultra encoding, you cannot route the upper 8 channels (9-16) to your
encoded clip unless 16 Channel audio is selected in 2.3 Audio Channels.
4. 1 Analog Audio
This parameter configures the analog audio signal levels for input and output.
+24dBu (default)
+18dBu
+15dBu
+12dBu
Professional audio equipment has much higher levels than consumer equipment:
a 0 VU reading corresponds to +4 dBu. Connecting a professional +4 dBu device
to a consumer audio input -10dBV (-7.8 dBu) may cause overloading, whereas the
output of a consumer device probably does not have sufficient power to drive a
professional audio input. With consumer and semi-professional audio equipment,
a VU reading of 0 dB is typically referenced to -10 dBV. 0 dBu = 0.775 VRMS.
6. 1 Genlock
This parameter selects the source of reference to genlock to during playback.
NOTE: Ki Pro Ultra always genlocks to the selected video input during capture; genlock
For general monitoring purposes, genlock is not required.
Input
Freerun (default)
Ref In
8.0 TC In
This parameter selects the source of timecode from those available.
TC Value (default)
SDI RP188
LTC
TIME OF DAY
Ki Pro Ultra File Based Recorder/Player v3.3r1
may only be needed during some playback configurations (such as in a facility
with a variety of other equipment).
Selects input channels 1-8.
Selects input channels 9-16
Selects pro-level USA signal levels of +24dBu
Selects pro-level Europe signal levels of +18dBu
Selects pro-level German signal levels of +15dBu
Selects consumer signal levels of +12dBu
NOTE: Maximum amplitude (0 dBFS)
Use the currently selected input as the Genlock source
Free run mode: Ki Pro Ultra syncs to its own timebase and is not
locked to an external source
Use the Ref Input as the Genlock source
Uses the value specified in parameter 8.1 TC Value
Uses the value from the SDI input
Uses the value from the LTC input
Sets timecode to the device clock value (55.6 Time Set)
50 www.aja.com