Gang Clip Name; Config Menus; Config Menu Parameters - AJA Ki Pro Installation And Operation Manual

42

22.1 GANG CLIP NAME

CONFIG menus

CONFIG Menu
Parameters
22.1 GANG CLIP NAME
This parameter is used when performing gang recording via multiple Ki Pros (refer to
Controlling Multiple Ki Pros later in this manual). If the desire is to have clips named
the same across all Ki Pro ganged units' recordings, then use the "Master Name"
selection in this parameter. If the desire is to have clips named independently on Ki
Pro units, then "Slave Name" should be selected. Selecting "Slave Name" means that
the recording will take it's name from the individual Ki Pro's parameters and not
accept the value pushed to the Slave by the Master Ki Pro.
Master Name (default)
Slave Name
When we talk about menus, we discuss the Parameter Number and Name on the top
line of the display and the Parameter Setting(s) possible as shown on the bottom line
of the display; remember, the current setting is what is shown.
As in the MEDIA menus already presented, pressing one of the parameter Adjust
buttons changes the current CONFIG parameter's value to a new one from the Ki Pro's
list of choices—repeating the list if you continue to press Adjust—or adjusting a
numerical value up or down.
The exact choices displayed will vary depending on the parameter. Most adjustment
choices made with the Adjust buttons take effect immediately and will be
subsequently stored into the Ki Pro's non-volatile memory if they remain unchanged
for 3 seconds.
If a Select or Adjust button is held down continuously, the changes will begin to
happen automatically - with acceleration if applicable.
Holding down both the Adjust (up) and Adjust (down) buttons—at the same time —
will set that parameter back to its factory default value.
The CONFIG menu is for system set-up and configuration. Each parameter is
numbered, just like the MEDIA menus.
Note: The composite output on the unit follows the component output; this means that the
composite output only works if either the source format or the convert format is SD.
Many of the CONFIG menu parameters are used together to configure the type of Ki
Pro recording and associated conversion formats used on the input or output for a
particular workflow.
Before we begin listing all of the individual CONFIG menu parameters, it's useful to
see how they can be used for an example application. Here are two examples of
making CONFIG menu selections for specific real world workflows.
Enable have clips named the same across all Ki Pro
ganged units
Name clips independently on Ki Pro units