Table of Contents
Advertisement
19.1 CUSTOM CLIP
19.2 CUSTOM NAME
19.4 CUSTOM TAKE
22.1 GANG CLIP NAME
CONFIG menus
Ki Pro Quad v5.2r3
This parameter enables or disables whether a custom clip name can be used via menu
parameters 19.1, 19.2, and 19.4, or via the web UI. These are the options:
OFF (default)
ON
This parameter defines a custom clip name. The custom name is defined via the front
panel select and adjust up/down arrows. The default is "CUSTOM". These are the options:
variable
This parameter defines a custom take. The custom take number is defined via the front
panel select and adjust up/down arrows. These are the options:
1 to 999
(default = 1)
This parameter is used when performing gang recording via multiple Ki Pros and/or Ki
Pro Quads (refer to Controlling Multiple Ki Pros later in this manual). If the desire is to
have clips named the same across all Ki Pro ganged units' recordings, then use the
"Master Name" selection in this parameter. If the desire is to have clips named
independently on Ki Pro units, then "Slave Name" should be selected. Selecting "Slave
Name" means that the recording will take its name from the individual Ki Pro's
parameters and not accept the value pushed to the Slave by the Master Ki Pro. These are
the options:
Master Name (default)
Slave Name
NOTE:
Most gang controls are only available in the web user interface.
When we talk about menus, we discuss the Parameter Number and Name on the top line
of the display and the Parameter Setting(s) possible as shown on the bottom line of the
display; remember, the current setting is what is shown.
Enable defining of custom clip name
Disable defining of custom clip name
Using the adjust buttons, enter a custom clip name. Using the
adjust buttons and the top Select button, select the
characters for the name. The adjust buttons scroll through
the choices and the top Select button advances to the next
character. While selecting characters, the character being
changed will flash to show its position. Certain characters
may not be allowed or supported if entered for a clip name.
Examples include: punctuation marks (other than internal
spaces or periods), special characters (like @), and non-
ASCII UTF-8 characters are rejected outright. Note: non-
UTF-8 characters appear in some languages, like Chinese
and Japanese, and are not supported.
Default: CUSTOM
Press ADJUST button up or down to change the
TAKE value from 1 to 999, if a value other than the
automatically generated value is desired.
Enable clips to be named the same across all Ki Pro ganged
units
Name clips independently on Ki Pro units
40
www.aja.com
Advertisement
Table of Contents
