Playing Back A Clip - AJA Ki Pro Ultra Installation And Operation Manual

To select a different video input, press CONFIG, then scroll with the User Control
Knob to 2.1 Video Input—then press the knob and scroll to a desired video input
connector and press the knob to select. To select a different audio input, use the
knob to access 2.2 Audio Input. Repeat the selection procedure to chose a desired
audio input connector.
Recording Notes
Ki Pro Ultra alerts you when the media is nearly full with a "Media Low" prompt
at 15% of the remaining capacity. At 10% of the total capacity of the media, the
"Media Full" prompt will appear. Any recordings that have been started will
stop once 10% is reached and no further recordings can be performed using
this media until it is formatted again or a MEDIA>Delete Clips>DELETE ALL has
been performed. Deleting clips to produce more than 10% free space will allow
recording to resume.

Playing Back a Clip

To playback recorded media, select a clip and press PLAY. If the clip you wish to
playback is not currently selected, use the User Control Knob to scroll until the
clip name appears on the bottom right of the display. Like recording, there is
more than one way to initiate playback (front panel or web browser). From the
front panel these are the basic steps:
1. Press the STOP button to get to the Transport mode (if not already there).
Find the clip name in the display (it shows the current Slot, Reel, and Clip
name).
2. Turn the User Control Knob until you find the clip you are looking for.
3. Press the PLAY (>) button.
4. When playing back a clip (PLAY, FFWD, or REV) the first push of STOP acts
as a "Pause" mode: the playback is paused, the current point of the clip
is displayed, and the STOP button will flash. A second push of STOP will
completely stop the playback and Ki Pro Ultra's outputs will go into an "E
to E" mode (the currently selected inputs will be bypassed to the outputs).
When a playback reaches the end of a clip, it will automatically pause on the
last frame of the clip.
Transport Buttons
During playback you can use the FFWD, REV, SELECT, or User Control Knob as
follows:
FFWD >>
Press button to begin fast playback of the current clip at 2x speed. Successive
pushes increase the speed to 4x, 8x, and 16x. (Pushing the button after 16x speed
is reached has no further effect.) When fast-forwarding, audio is muted.
REV <<
Pressing REV when not highlighted, begins playback of the current clip in reverse
at 1x speed. Successive pushes increase the speed to 2x, 4x, 8x, and 16x. (Pushing
the button after 16x speed is reached has no further effect.) When playing in
reverse, audio is muted for all speeds.
User Control Knob
While in Transport mode, the User Control Knob will scroll through the clips in the
active media. When a clip is selected it is "cued" to the beginning of the clip. Note
that ordering and playback of clips is based on timestamp order, not clip name.
Ki Pro Ultra File Based Recorder/Player v3.3r1 32 www.aja.com