AJA Ki Pro Ultra Installation And Operation Manual page 51

8. 1 TC Value
This parameter selects an hour value from which timecode begins incrementing.
00:00:00:00 to 23:00:00:00
(Default: 01:00:00:00)
8.2 TC Type
This parameter selects drop frame or non-drop frame timecode.
NDF (default)
DF
NOTE: If the menu parameter 8.0 TC In is set to SDI RP188 or LTC, the TC Type selection
8.3 Arm Recording
This parameter selects how recording may be initiated, either by pressing the
physical record button (or the web "record" button), or via timecode.
REC KEY (default)
TC/REC KEY
If arm recording on timecode, parameters 8.0, 8.1, and 8.2 must be set to a
qualified source and type of timecode. You should use timecode that starts and
stops, like that produced by record run timecode; freerun timecode is not viable
for this feature since it does not produce start and stop values.
9.0 Interval Record
The Ki Pro Ultra can be used to create timelapse recordings via the 9.0 Interval
Record, 9.1 Interval Frames and 9.2 Interval Time selections.
OFF (default)
ON
Example of timelapse recording selections:
The incoming video signal is 1080i 29.97 fps, the record button is depressed, and
the recording is then stopped 90 seconds later with the following settings:
• 9.0 Interval Record > On
• 9.1 Interval Frames > 1
• 9.2 Interval Time > Second
The resulting recording would be 90 frames in duration, would have a frame
rate of 29.97 fps, and would appear to be "under cranked" or "sped up" when
compared to a normally created recording.
NOTE: Selecting an interval frame number that exceeds the incoming video frames per
9. 1 Interval Frames
Determines how many frames from the incoming video will be used for the
recording.
Incrementing Value
Ki Pro Ultra File Based Recorder/Player v3.3r1
does not apply. TC Type only applies to the TC Value or the Time of Day value
generated by the Ki Pro Ultra.
second will result in normal video. "Over cranking" or "slow mo" is not supported
by the interval recording feature.
Use the User Control Knob to select a timecode hour.
For example: 01:00:00:00, 02:00:00:00, etc.
Selects Non-drop Frame timecode
Selects Drop Frame timecode
Start when Record button is pressed
Start on Time Code or Record button
Normal recordings are produced.
Timelapse recordings are produced.
Sets number of frames to use for the recording.
51 www.aja.com