AJA Ki Pro Ultra Installation And Operation Manual page 54

41.3 Audio SG
This parameter determines the audio signal output from Ki Pro Ultra's internal test
signal generator.
OFF (default)
Silence
1 kHz
50. 1 IP Config
This parameter determines the type of TCP/IP network configuration used by
Ki Pro Ultra.
Static ADDR
DEFAULT ADDR
DHCP (default)
NOTE: With parameters 50.1, 50.2 and 50.3, there is no timeout when editing—changes
50.2 IP Address
This parameter determines the static IP address used by Ki Pro Ultra for TCP/IP
networking.
variable
NOTE: For parameters 50.2, 50.3, and 50.4, you will be setting IP addresses that consist of
50.3 Subnet Mask
This parameter determines the subnet mask used by Ki Pro Ultra for TCP/IP
networking.
variable
Please read the "Note" about editing IP addresses in parameter 50.2 as it also
applies to parameters 50.3 and 50.4.
Ki Pro Ultra File Based Recorder/Player v3.3r1
made while in these menus will be saved and activated when the menu is exited.
"octets" separated by a period (i.e., 10.0.181.0). To edit these, press the User Control
Knob to access the alpha-numeric keyboard to enter the desired IP Address. When
complete click the SAVE function.
Turn audio test signal output OFF.
Output an audio test signal containing silence only.
Output a standard 1 kHz test signal tone.
Assign a static IP address manually (parameters 50.2, 50.3, and
50.4 will have to be entered to accomplish this).
Use the factory default static IP address: 10.65.74.65
Select automatic IP address assignment from DHCP server on
LAN.
NOTE: if Ki Pro Ultra cannot find a DHCP server to communicate
with, it will select the default factory IP address of 192.168.0.2.
Using the User Control Knob, enter an IP address compatible
with your LAN (if you have one). If direct connecting to a
computer, enter a legal IP address that you'll also enter in
the computer's web browser. This is only needed for Static IP
configurations.
NOTE: If 50.1 is set to DHCP and there is a DHCP failure, then the
default IP address is: 192.168.0.2
NOTE: If 50.1 is set to Default Addr, the default static IP address
is: 10.65.74.65
Using the User Control Knob, enter a subnet mask compatible
with your LAN (if you have one). This is only needed for Static
IP configurations.
NOTE: If 50.1 is set to DHCP, the default Subnet Mask will be
assigned by the DHCP server
NOTE: If 50.1 is set to Default Addr, the default Subnet Mask is:
255.0.0.0
54 www.aja.com