Switcher Error Responses - Extron electronics ISS 608 User Manual

Effect Select
X1(]
SwefO1*
Logo Event
X@
LogoE *
X@
LogoE *0
Take Event
]
Tke
]
Bsy1
]
Bsy0
Video Mute Event
X@ ]
Vmt *1
X@ ]
Vmt *2
X@ ]
Vmt *0
Video Freeze Event
X@ ]
Frz *1
X@ ]
Frz *0

Switcher Error Responses

When the switcher receives an SIS command and determines that it is valid, it performs the
command and sends a response to the host device. If the switcher is unable to perform
the command because the command is invalid or contains invalid parameters, the switcher
returns an error response to the host. The error response codes are:
E01 — Invalid input number
•
• E10 — Invalid command
• E11 — Invalid preset number
E12 — Invalid port or output number
•
E13 — Invalid parameter
•
E14 — Invalid for this configuration
•
NOTE: If the unit does not support or recognize the entered commands, no response
will be issued.
Broadcast upon selection of a new effect (for example: dissolve,
cut, wipe, video key, and PIP).
X8)]
Broadcast when a Logo is turned on for output
]
Broadcast when a Logo is turned off for output
Broadcast upon a Take event.
Broadcast upon the start of a Take effect.
Broadcast upon the completion of a Take effect.
Broadcast when video is muted on output
Broadcast when video and sync are muted on output
Broadcast when video is unmuted on output
Broadcast when video is frozen on output
Broadcast when video is unfrozen on output
X@
.
X@
X@
.
X@
E17 — Invalid command for signal type
•
• E22 — Busy
• E24 — Privilege violation
E25 — Device not present
•
E26 — Maximum number of connections
•
exceeded
E28 — Bad Filename / File not Found
•
ISS 608 Seamless Switcher • Introduction
X@
.
X@
.
X@
.
.
.
37