Technical Specifications Of 19" Slide-In Module 4 To 20 Ma - Siemens SIPART PS2 Series Operating Instructions Manual

Positioner with remote control electronics
F.2 19" slide-in module
5. Connect the wires of the cable
connector
6. Connect the positioner 6DR5910
connector
7. Connect the wires of the cable
as the SUB-D female connector
8. Connect the 19" slide-in module
connector
F.2.3

Technical specifications of 19" slide-in module 4 to 20 mA

You can find the valid technical specifications for the positioner Technical data (Page 239). The
technical specifications valid for the 19" slide-in module 4 to 20 mA are set out below.
Rated conditions
Degree of protection
● Front
● Back page
Mounting position
Vibration resistance
● Harmonic oscillations (sine wave) according to
DIN EN 60082-2-6/05.96
● Oscillations (sinusoidal) according to
DIN EN 60068-2-6/04.96
● Shock (half-sine) according to DIN EN 60068-2-27/02.2010 150 m/s² (492 ft/s²), 11 ms, 6 shocks/axle
316
①
according to the following table:
Connecting Assignment
terminals
④ ⑤
/
2 GND
3 Vref
4 Vcc
5 Vpos
①
.
Assignment of female connector
1 Signal source +
2 Signal source -
3 -
4 -
5 -
⑦
.
②
to the connecting terminals
Assignment, Connecting
male terminals
① ④
connector /
7 6
6 7
- 8
4 9
10
③
with the 19" slide-in module
⑧
to the signal source
⑦
according to the following table:
⑦ ⑨
for Assignment of female connector
6 -
7 -
8 U
9 U
⑬
with the control system
IP40 acc. to DIN EN 60529
IP20 acc. to DIN EN 60529
Any
3.5 mm (0.14"), 5 ... 8.4 Hz, 4 cycles/axle
10 m/s² (33 ft/s²), 8.4 ... 500 Hz, 4 cycles/axle
KWU DD 7080.9/93
KTA 3503 from 11.86
Operating Instructions, 11/2019, A5E00074631-AE
④
and to the SUB-D male
Assignment Assignment,
male
⑥
connector
Not assigned -
Discharge + 2
Discharge - 1
Supply + 15
Supply - 14
⑬
using the SUB-D male
⑨
and the power source
+
Aux
-
Aux
⑩
using the SUB-D female
SIPART PS2 with 4 to 20 mA/HART
①
⑪
as well
⑦ ⑪
for