Siemens SIPART PS2 Series Operating Instructions Manual page 277

Description
The dimensions of magnet and NCS can be found under Dimensional drawing of non-
contacting sensor (Page 285).
Dimensions in mm
A
B
C
①
②
Figure B-5
Procedure
1. Produce the mounting panel
2. Align the sensor to the center of the stroke. Observe the dimensions specified in the figure.
SIPART PS2 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E00074631-AE
Mounting on a yoke with fin
Mounting on a yoke with plane surface
Mounting on a yoke with columns
NAMUR mounting bracket IEC 60534 -
not included in the scope of delivery
Assembly panel for Non Contacting
Sensor (NCS) - individual solution; not
included in the scope of delivery
Example of the assembly on a linear actuator with a stroke up to 14 mm (0.55 inch)
③
Non Contacting Sensor (NCS)
④
Hex socket head screw M6x25
⑤
Magnet
⑥
Hex socket head screw M6x12
⑦
Mounting bracket for the magnet - individual
solution; not included in the scope of delivery
②
and mounting bracket
External position detection
B.2 Non-Contacting Sensor
⑦
individually.
277