Siemens SIPART PS2 Series Operating Instructions Manual page 315

Connecting
①
D-SUB male connector 15-pin
②
Cable to the positioner 6DR5910
③
Positioner 6DR59..
④
Connecting terminals, positioner
⑤
Signal cables for potentiometer
⑥
Signal cables for pneumatic block
⑦
D-SUB female connector 9-pin
Figure F-4 Connecting basic electronics to power supply
Procedure
Observe the safety instructions for connection in section Basic safety instructions (Page 75).
1. Strip 5 mm of the cable shield on the cable
2. Open the positioner 6DR5910. Unscrew the four fixing screws of the enclosure cover.
3. Insert the prepared cable
4. Tighten the cable entry.
SIPART PS2 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E00074631-AE
Positioner with remote control electronics
⑧
⑨
⑩
⑪
⑫
⑬
⑭
②
.
②
through the cable entry of the positioner.
F.2 19" slide-in module
Cable to control system
Signal source
Control system
Auxiliary power supply U
Aux
Earth potential
Control electronics in the 19" slide-in module
4 to 20 mA
Channel 1 of 3
315