B.4 Updating The Tpu/Sp-Iii Tpu Software - Klein 4000 Series Operation And Maintenance Manual

B-4
APPENDIX B Configuring and Updating the TPU/SP-III TPU
5. Enter the TPU/SP-III TPU IP address in the Enter TPU IP Address text box if it
is different than the default address, or click
default address is 192.168.0.81. The address will already be displayed if it was
queried or changed as described in "Querying or Changing the TPU/SP-III TPU
IP Address" on page B-2.
6. Click Edit startup.ini .
Windows Notepad opens with the contents of the startupCdi3000.ini file
displayed.
7. Make the required changes to the startupCdi3000.ini file as required, and then
exit Notepad.
Notepad exits and the changed file is saved. The TPU/SP-III TPU software
restarts and a window opens confirming the file update:
8. To ensure a clean start with the new update, in about 20 seconds, turn the
TPU/SP-III TPU off and then on again.

B.4 Updating the TPU/SP-III TPU Software

Updates to the TPU/SP-III TPU software are supplied as compressed archive files
and must reside on the SonarPro Workstation or the laptop computer.
To update the TPU/SP-III TPU software:
Connect the supplied Ethernet cable to the ETHERNET connector of the TPU
1.
and to the Ethernet port of the SonarPro Workstation, or to the LAN connector
of the SP-III TPU and to the Ethernet port of the laptop computer.
2. Turn on the SonarPro Workstation or the laptop computer and wait for the
Windows desktop to appear.
3. Turn on the TPU, or turn on the SP-III TPU by switching the A/C-D/C switch to
A/C for AC operation or to D/C for DC operation.
4. Start Linux TPU Updater.
The Klein Linux TPU Updater dialog box opens.
Series 4000 Sonar System Operations and Maintenance Manual
if it is the default. The
Default Addr
P/N 11210094, Rev. 01