Connecting The Sp-Iii Tpu And The Laptop Computer; Table 3-2: Towfish Jumper Cable Connector Pinout - Klein 4000 Series Operation And Maintenance Manual

3-14
CHAPTER 3 Setup and Test
3.6.2
The following supplied cables are used to connect the SP-III TPU and the laptop
computer:
• Ethernet crossover cable
• DC power cable
• AC power cable
• Tow cable
For the connector pinouts and pin orientations for each of the connectors on the
SP-III TPU side panel, refer to Table 3-3 through Table 3-8. For the connector
pinout and orientation of the towfish jumper cable connector, refer to Table 3-2.
Table 3-2:
PIN
the towfish or the SP-III TPU electronics, or to both. For the location of the power
switches, refer to "Topside System Controls and Indicators" on page 3-17.
To connect the SP-III TPU and laptop computer:
Connect the Ethernet crossover cable to the LAN connector on the TPU and to
1.
the Ethernet port of the laptop computer.
Connect a GPS to the NAV connector on the SP-III TPU. A user supplied
2.
RS-232 serial cable is required where one end is terminated with a DB9
female connector and the other end is as required by the navigation system.
Series 4000 Sonar System Operations and Maintenance Manual

Connecting the SP-III TPU and the Laptop Computer

Towfish Jumper
Cable Connector
Pinout
FUNCTION
200 VDC Power
1
and Telemetry
2 Shield
WARNING Before connecting the topside system components, verify that
the SP-III TPU is turned off and that its power cable is disconnected.
Failure to follow this practice may result in personal injury or damage to
P/N 11210094, Rev. 01