Klein 4000 Series Operation And Maintenance Manual page 41

Connecting the Topside System Components
Connect the keyboard and the mouse to any two of the six USB connectors on
3.
the SonarPro Workstation.
Connect a GPS to the NAV connector on the TPU. A user supplied RS-232
4.
serial cable is required where one end is terminated with a DB9 female
connector and the other end is as required by the navigation system.
Verify that the GPS is outputting NMEA-0183 formatted data strings at
5.
4800 baud, no parity, 8 data bits, and 1 stop bit. In addition, the GPS should be
outputting the following messages:
• GLL or GGA
• VTG
• RMC (optional)
NOTE If 4800 baud is not available from the GPS, contact KMS customer
service for instructions on how to reconfigure the system to accept a
different baud rate. Refer to "Customer Service" on page xvi for
information on how to contact KMS customer service.
Connect the deck cable to the TOWFISH connector on the TPU and to the
6.
slip rings of the optional winch.
For the predeployment checks, the deck cable can be temporarily
NOTE
connected to the TOWFISH connector on the TPU and to the towfish.
Connect an AC power cable to the AC INPUT connectors on the TPU and the
7.
SonarPro Workstation and to the AC power source.
The following connections are optional:
Connect the 1 PPS IN connector on the TPU to the 1 PPS output of the
8.
shipboard GPS. A user supplied BNC-to-BNC cable is required.
Connect the EXT TRIG IN connector on the TPU to the trigger output of an
9.
external source. A user supplied BNC-to-BNC cable is required.
Connect the T/F TRIG connector on the TPU to the trigger input of an
10.
external sonar system. A user supplied BNC-to-BNC cable is required.
Connect the TRIG A connector on the TPU to the trigger input of a USBL
11.
system. A user supplied BNC-to-BNC cable is required.
3-13