Klein 4000 Series Operation And Maintenance Manual page 64

4-12
CHAPTER 4 Equipment Maintenance
Set the transducer assembly
4.
down with the transducer
facing up.
Using the 4-mm hex key,
5.
remove the four socket
head cap screws on the face
of the transducer, two on
each end.
Turn the transducer
6.
assembly over, and using
the Phillips head
screwdriver, remove the
eight screws securing the
transducer to the transducer
assembly.
Separate the transducer
7.
from the transducer
assembly.
Repeat Steps 2 through 7 to
8.
remove the other
transducer.
Series 4000 Sonar System Operations and Maintenance Manual
Socket head
cap screw
(2 each end)
Location of the Four Socket Head
Figure 4-17:
Cap Screws on the face of a Transducer
Removing the Eight Phillips Head
Figure 4-18:
Screws Securing the Transducer
P/N 11210094, Rev. 01