Klein 4000 Series Operation And Maintenance Manual page 44

3-16
CHAPTER 3 Setup and Test
Verify that the GPS is outputting NMEA-0183 formatted data strings at
3.
4800 baud, no parity, 8 data bits, and 1 stop bit. In addition, the GPS should be
outputting the following messages:
• GLL or GGA
• VTG
• RMC (optional)
information on how to contact KMS customer service.
Connect the tow cable to the TOWFISH connector on the SP-III TPU.
4.
Connect the AC power cable to the 120/240 VAC connector on the SP-III
5.
TPU and to the AC power source, or connect the DC power cable to the 12
VDC connector on the SP-III TPU and to a 12 VDC power source, or both.
To run the laptop computer from AC power, connect it to its power supply and
6.
connect the power supply to the AC power source.
The following connections are optional:
Connect the 1 PPS IN connector on the SP-III TPU to the 1 PPS output of the
7.
shipboard GPS. A user supplied BNC-to-BNC cable is required.
Connect the EXT TRIG IN connector on the SP-III TPU to the trigger output
8.
of an external source. A user supplied BNC-to-BNC cable is required.
Connect the T/F TRIG connector on the SP-III TPU to the trigger input of an
9.
external sonar system. A user supplied BNC-to-BNC cable is required.
Connect the RESP TRIG connector on the TPU to the trigger input of a USBL
10.
system. A user supplied BNC-to-BNC cable is required.
Series 4000 Sonar System Operations and Maintenance Manual
NOTE If 4800 baud is not available from the GPS, contact KMS customer
service for instructions on how to reconfigure the system to accept a
different baud rate. Refer to "Customer Service" on page xvi for
P/N 11210094, Rev. 01