Installing The Transducers - Klein 4000 Series Operation And Maintenance Manual

Disassembling and Reassembling the Towfish
4.3.4

Installing the Transducers

To install the transducers:
Reverse Steps 2 through 7 in "Removing the Transducers" on page 4-11 for
1.
each transducer.
Connect the two transducer cables, matching the colors with the connectors on
2.
the forward end cap.
Slide the nose cone into the towfish housing, aligning the locator pin on the
3.
nose cone with the slot in the housing and threading the nose cone retaining
bolt into the end cap as shown in Figure 4-12 on page 4-9.
Tighten the nose cone retaining bolt.
4.
4-13