Sonarpro Workstation Connections; Sp-Iii Tpu Connections - Klein 4000 Series Operation And Maintenance Manual

3.5.2

SonarPro Workstation Connections

All the connections to the SonarPro Workstation are made to connectors on the
back panel which is shown in Figure 3-3.
The SonarPro Workstation connectors are the following:
USB:
DVI:
ETHERNET:
AC INPUT:
3.5.3

SP-III TPU Connections

All the connections to the SP-III TPU are made to connectors on the side panel
which is shown in Figure 3-4.
The SP-III TPU connectors are the following:
TOWFISH:
LAN:
T/F TRIG:
RESP TRIG:
EXT TRIG IN:
1PPS:
MAG:
Topside System Connections
USB connectors (4, plus 2 on the front panel). Any
two connect to the keyboard and the mouse. The
front panel USB connectors are shown in Figure 3-6
on page 3-20.
DVI connector that connects to the monitor.
RJ-45 connectors (2). Any one connects to the
ETHERNET connector on the TPU.
IEC type AC input connector that connects to the
AC power source.
8-pin female bulkhead connector that connects to
the towfish using the tow cable.
RJ-45 connector that connects to the Ethernet port of
the laptop computer. The SP-III TPU uses a
100BaseTx Ethernet connection.
BNC connector that provides a trigger output pulse
for keying external equipment.
BNC connector that provides a trigger output pulse
for keying a responder.
BNC connector that is used to input an external
trigger pulse for keying the sonar.
BNC connector that is used to input a 1PPS timing
pulse.
DB9 female connector that connects to a serial port
of the magnetometer control computer. The baud
rate is 9600.
3-9