W&H Lisa VA131-17 Instructions For Use Manual page 32

Getting started
On the homepage tap
1
.
If the connection is through the
2
Ethernet cable, tap : the TCP/IP
screen appears.
If the connection is through Wi-Fi
3
key, tap : after a while, the
sterilizer shows the available
networks found. Choose the
network, enter the credentials in
the further screen, then tap
confirm: the TCP/IP screen appears.
Note: the and icons are disabled
if the connectivity means (cable or Wi-
Fi key) are not properly plugged.
32
> >
to
Note: in the TPC/IP screen, the
icon is visible only if you make any
change. The Wi-Fi icon at the
bottom will not be visible if you
connect through Ethernet cable.
If your network supports dynamic IP
4
addresses (ask your IT manager),
enable the options Dynamic both in
IP Configuration and in the DNS
Configuration fields, then tap
confirm: all entry fields are
disabled.
If your network does not support
5
dynamic IP addresses (ask your
IT manager), enable the options
Static both in IP Configuration and in
the DNS Configuration fields. Tap on
each entry field and enter the IP
addresses (ask your IT manager for
details). Then tap to confirm.
LISA | Instructions for Use | VA131 2019 ENG Rev06 | 16/04/2020 | © 2020 W&H Sterilization Srl
to