Diagnostics; Errors - W&H Lisa VA131-17 Instructions For Use Manual

Diagnostics

CONTENTS
This section deals with the following subjects:

Errors

Troubleshooting
Emergency door opening
Errors
CHECKS AND ACTIONS
Notice: For any error not listed in this table, call technical service.
Code
0xx Load cannot be considered sterile. See "End of a sterilization cycle" on page 67
Check if the mains switch or network circuit breaker is OFF.
Check if the mains cable is properly connected.
Switch the sterilizer OFF and ON.
Set date and time, then switch the sterilizer OFF and ON.
Check the dust filter and ensure that the sterilizer fan is not blocked.
10x See error "13x to 16x" on the next page.
100
Description
LISA | Instructions for Use | VA131 2019 ENG Rev06 | 16/04/2020 | © 2020 W&H Sterilization Srl
Actions
Repeat the cycle.
If the problem persists, call service.
Repeat the cycle.
If the problem persists, call service.
100
105
113