W&H Lisa VA131-17 Instructions For Use Manual page 43

connected to the sterilizer, while the shared label printer is
connected to another sterilizer in the network.
SELECT AND CALIBRATE A LOCAL LABEL PRINTER
On the homepage tap
1
Tap : the local printer is located
2
automatically.
Tap to center the printout
3
properly in the label area.
Tap to print a test label.
4
If the printout is not duly centered,
5
tap or to center it
horizontally (x) and vertically (y).
If necessary, tap to print
6
another test label and repeat step
4.
Tap to confirm the settings and
7
go back to the previous page.
LISA | Instructions for Use | VA131 2019 ENG Rev06 | 16/04/2020 | © 2020 W&H Sterilization Srl
> >
SELECT A SHARED LABEL PRINTER
Ensure the sterilizer to which the
1
printer is physically connected is
ON and no cycle is running.
From that sterilizer, tap
2
.
Depending on the LAN connection,
3
take note of the Ethernet or Wi-Fi IP
address.
Do not switch OFF the sterilizer
4
until the whole procedure is
complete.
Managing printers
> >
43