Chapter 3 Using The Menus - Satec C191HM Installation And Operation Manual

Chapter 3 Using The Menus

3.
Press and release
appear:
StA
OPS
CHG
Press again to activate the window of the desired primary menu.
SELECT
Press ENTER .
Select CHG to initialize or modify the instrument setup, or to clear the accumulated values
stored in the instrument. Entry to this menu can be protected by a password.
Select StA to view extended status information which may be useful during installation and
in certain applications.
Select OPS for viewing (not editing) the instrument setup options.
After selecting either OPS or CHG, the list of setup menus is displayed in the
upper window. Figure 3-1 presents a complete menu list. Depending on the
model of your instrument, some menus may not appear.
Password
The Setup Change Menu can be secured by a user-defined password comprised
of 4 digits. The instrument is shipped with password protection disabled. To
enable password protection, go to the Access Control Menu (see Section 4.10).
The Password Menu appears if password protection is enabled.
To enter a password:
Set the first digit using the up and down arrow keys.
Press SELECT
Set the other password digits in the same manner.
ENTER
Press
to the Primary Selection Menu.
18
SELECT to enter the setup mode. The primary menus will
- Status Information Menu (see Chapter 6)
- Setup Options Menu
- Setup Change Menu (see Chapter 4)
CHG
SELECT
StA
SELECT
OPS
SELECT
to advance to the next digit.
to continue setup. If your password is incorrect, you will return
ENTER
ENTER
ENTER
PASS
0000
Chapter 3 Using the Menus