Pepperl+Fuchs VBG-PB-K25 Manual page 86

Set the toggle bit:
Byte 1
Byte 2
Byte 3
Byte 4
Byte 5
Byte 6
...
Byte 12 00
Byte 1
Byte 2
Byte 3
Byte 4
...
Byte 12 00
The single slave configuration for the 16-bit module is written.
This command must be repeated for all 31 A-slaves and all 31 B-slaves. If you
don't connect a slave to an address, write F
3. Write new list of projected slaves
Write the complete LPS of your AS-i circuit.
Every bit in the LPS corresponds to one slave after the following scheme:
Byte0/Bit 0:slave 0/0A - can not be set!
Byte1/Bit 1:slave 1/1A
...
Byte3/Bit 7:slave 31/31A
Byte4/Bit 0:slave 0B - can not be set!
Byte4/Bit 1:slave 1B
...
Byte7/Bit 7:slave 31B
The slave is projected if the bit is set.
Subject to reasonable modifications due to technical advances.
84
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Request: SET_PCD
0C (SET_PCD)
hex
80 (T = 1, master 1, single master)
hex
04 (slave address to write to master)
hex
EF (ID + IO to configurate)
hex
37 (ID + IO to configurate)
hex
00
hex
...
hex
Response
25
hex
80 (T = 1, result = 0)
hex
00 (or old values)
hex
00 (or old values)
hex
...
(or old values)
hex
AS-Interface
Command Interface
for ID, IO, ID1, ID2.
hex
Copyright Pepperl+Fuchs, Printed in Germany