Setup; Attach The Lower Rails And Table Ends; Attach Frame Braces - Ferno 103 User Manual

Setup

Follow the instructions in this section to prepare the table for use. All hardware is supplied.
4.1 attach the lower rails
and Table ends
1. One Allen-head screw and two lock washers are
threaded into each of the four table-end wheel
castings. Remove these parts from their shipping
positions using the 3/16" Allen wrench provided
with the table.
2. Insert the lower rails into the table-end corner
castings (Figure 1). Verify that the holes for the
frame braces and table-ends are properly aligned
as follows:
The frame-brace mounting holes must face
○
straight upward as shown in Figure 1 (not at
an angle).
The holes at the ends of the lower-rails are
○
angled to properly align with the table-end
castings. After inserting the lower rails into
the table ends, verify that these holes are
visible in the table-end castings.
If the holes in the lower rail are not visible
○
inside the table-end castings OR if the
frame-brace holes are not facing straight
up, turn the lower rail end-for-end.
3. Verify that there are two lock washers on each of
the four Allen-head mounting screws.
4. Secure the rails to the table ends using the 3/16"
Allen wrench and four socket-head cap screws
provided (Figure 1 inset).

4.2 attach Frame braces

Use a #2 Phillips screwdriver to attach the four frame
braces to the lower rails and corner posts using the
eight Phillips pan-head screws provided (Figure 2).
8
4 - seTUP
Table End (2)
Mounting Hole (4)
Figure 1 - Attaching the Lower Rails and Table Ends
Figure 2 - Attaching the Frame Braces
© Ferno-Washington, Inc 234-0037-05 August 2009
Model 103 Combination Table
Frame-Brace
Frame Brace
Phillips
Pan-Head
Screw
Lower Rail (2)
Socket-Head
Cap Screw (4)