Maintenance - 20H; Engine Oil And Oil Filter - Change - Fayat Group Dynapac CC900G Instruction Manual

3
Fig. Engine compartment, left side
1. Drain hose
2. Plug
3. Oil filter
Fig. Engine compartment, right side
4. Filler cap
2019-09-23

Maintenance - 20h

Engine oil and oil filter - Change

Run the engine until it is warm before draining the oil.
1,
2
2
Place a receptacle that holds at least 4 liters (1 gal.)
under the drain plug (2).
Undo the oil filler cap (4) and remove the plug (2) from
4
the end of the drain hose (1); allow all the engine oil to
run out.
Remove the oil filter (3) and insert a new one.
Collect any spillage.
4812163901_A.pdf
Park the roller on a level surface. Park the roller on a level surface.
The engine must be switched off and the The engine must be switched off and the
parking brake activated when checking or parking brake activated when checking or
adjusting the roller, unless otherwise specified. adjusting the roller, unless otherwise specified.
Check that the engine cover is fully open before Check that the engine cover is fully open before
carrying out work underneath it. carrying out work underneath it.
Switch off the engine and push in the Switch off the engine and push in the
reserve/parking brake knob. reserve/parking brake knob.
Take great care when draining fluids and oils. Take great care when draining fluids and oils.
Wear protective gloves and goggles. Wear protective gloves and goggles.
Deliver the drained oil to special waste handling. Deliver the drained oil to special waste handling.
Refer to the engine manual for detailed Refer to the engine manual for detailed
instructions when changing oil and filters. instructions when changing oil and filters.
Maintenance - 20h
65